Quote
Jason22 wrote:
im not new.. i may not have many posts but certainly not new. and when i mean they dont show in panel.. im not talking when you save then enable.. im talking about previewing the panel before saving it to continue then enable it.
Quote
And wrote:Quote
Jason22 wrote:
im not new.. i may not have many posts but certainly not new. and when i mean they dont show in panel.. im not talking when you save then enable.. im talking about previewing the panel before saving it to continue then enable it.
Did you type your ADMIN PASSWORD , if you don't you cannot Prewiev & Save !
Quote
But for some reason even with password and then preview, with panels that are already pre installed. after doing password and preview, nothing shows. it just stays the same.
Quote
hammer wrote:
I have the same problem
Can't preview any panel ....
I enter new password but nothing
Quote
slaughter wrote:Quote
hammer wrote:
I have the same problem
Can't preview any panel ....
I enter new password but nothing
You should not enter a new password.
You should use your admin password!
Category Forum
System Administration - 8Labels
None yet
Statistics
6 participants
Notifications
You are not receiving notifications from this thread.
Related Questions